The non-cylindrical surface with a small length can be processed by CNC milling or wire cutting. In order to adapt to the processing of cylindrical workpieces with complex curves, the CNC system has been modified by CNC. The CNC system has become a set of functions such as real-time machining control, automatic graphic programming, tool wear compensation, simulation and dynamic tracking of machining tracks. Integrated control system. The method of numerical transformation of the bullhead planer is to use a stepper motor driven CNC tool holder and a stepper motor drive. Install three proximity switches near the ram and install a simple tool setting on the workbench. The automatic operation is the core part of the CNC system operation control. The command is M32. The tool and the workbench make intermittent movement according to the reciprocating motion signal of the ram. If it is M33, the fast air running function. If the ram stops reciprocating during machining, the feed motion stops. This function allows workers to follow the operating habits of ordinary planers. The CNC system adopts an open PC bus structure on the hardware, and the stepping motor speed is controlled by the 8253 on the interface board. The programming can be programmed in a variety of ways, with automatic graphical programming and manual programming. Enter the straight lines and arcs of each segment according to the direction of the curve. An equidistant curve is generated according to the required tool nose radius. The offset curve is fitted with a straight line according to the given accuracy requirement, and the generated machining program is run in the simulation running mode, and the trajectory of the tool nose running is dynamically displayed. (Finish) Antioxidant 1076,Antioxidant 1076 Msds,Antioxidant 1076 Tds,Cas Number Antioxidant 1076 SHANDONG MINGDE CHEMICAL CO.,LTD. , https://www.sdmingdechem.com